DeVillbiss Air Power Company PowerBack GM1000 Guía para resolver problemas descargar pdf (Pagina 9)

9 — ENG

MG-GENMAN-F

ASSEMBLY

Read this manual. Do not attempt to operate

equipment until you have read this Manual for

Safety, Operation, and Maintenance Instructions.

NOTE: This manual is a general manual. Information

in this manual may or may not pertain to your model.

Please read carefully.

NOTE: Left and right describes the location of a part

with the operator facing the outlet panel.

REMOVE GENERATOR FROM CARTON

• Open carton from top.

• Cut carton along dotted lines.

• Remove all carton inserts.

• Remove generator through opening in carton.

• (if equipped) Remove shipping block from under

the gen head by unscrewing the bolt and remove the

wood block. It is very important that this is removed

before starting your generator. See Figure 1.

IMPORTANT: Before any attempt to start your generator

be sure to check engine oil (See Engine Operator's

manual)

GROUNDING THE GENERATOR

A grounding lug is supplied with the generator for use

when required by local electrical ordinances. Refer to

article 250 of the National Electrical Code to clarify any

needed grounding information. Your local electric

company or a certified electrician should be able to help

you with this information.

Figure 1

TYPICAL INSTALLATION OF BATTERY

(Electric Start Units Only)

● Recommended Battery for Electric Start: 12V - 45

A H. or 210 CCA (Cold Cranking Amps)

● Purchase battery and battery hardware separately,

not included with unit.

1. Place battery in rack with terminals facing towards

generator head.

2. Place battery bracket (A) over battery as shown in

Figure 3 (opposite battery terminals).

3. Place "L" bolt (B) through top and bottom brackets

and secure with wing nut (C).

To Prevent sparks connect the red (positive)

cable to the positive (+) terminal before connect-

ing the black negative cable.

4. Locate the solenoid on the left side of the unit. See

Figure 4 and 5.

For GBE4010 and GBFE6010

5. Remove the nut from the solenoid post with the

panel assembly wire harness. Place one end of the

positive (red) battery cable onto this post with the

panel assembly wire. Reassemble nut and tighten

securely. See Figures 4.

Figure 3

Figure 4

Grounding Lug

Figure 2

NOTE: Your engine is already grounded to the frame by

a grounding strap.

Panel Assembly

Wire Harness

Solenoid

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comentarios a estos manuales

Sin comentarios

DeVillbiss Air Power Company PowerBack GM1000 Guía para resolver problemas Pagina 9

Comentarios a estos manuales